Generation 2 R-Spec controller wiring by Rabbit

ECU - Mitsubishi Genuine Part Number MD331116, MD335999

(B-59)


1	2	3									12	13
1	2	3	4	5	6	7	8	9	10	11	12	13
14	15	16									25	26
14	15	16	17	18	19	20	21	22	23	24	25	26

(B-60)



31	32	33	34	35	36	37	38

39	40	41	42	42	44	45	46

(B-61)



51	52	53	54	55	56

57	58	59	60	61	62

(B-62)


71									80	81
71	72	73	74	75	76	77	78	79	80	81
82									91	92
82	83	84	85	86	87	88	89	90	91	92

Maybe compatable with all of the following MD335299, MD352555, MD336610, MD352556, MD334383, MD331116

R-Spec MIVEC Controller

26 = Join the Black into the wiring without breaking the connection
34 = Cut and connect Blue to the ECU and Yellow to the wiring going to the engine
35 = Cut and connect Purple to the ECU and Brown to the wiring going to the engine (only needed on the V6 engines)
58 = Join the Orange into the wiring without breaking the connection
80 = Join the Red into the wiring without breaking the connection
82 = Join the Green into the wiring without breaking the connection
86 = Cut and connect Pink to the ECU and Grey to the wiring going to the engine

Notes:

If you have only the hand controller you will not have the wire colours above.
Below is a list of hand controller colours and the harness colour(above) it connects to, using both the wire colour and tiny pin numbers on one side the small black connector at the end of the hand controller cable.

1, White = Red
2, White = Green x2*
3, White = Black
4, Orange = Pink
5, Orange = Grey
6, Orange = Brown
7, Orange = Brown*
8, Yellow = Yellow
9, Yellow = Orange
10, Yellow = No connection
11, White = Blue
12, Yellow = Purple

* Brown and one Green go to 2pin connector, Not wired into the car. I suspect it is for a shift or MIVEC engaged light.